Archive
-
Why do LED bulbs get dimmer the more they are used? Why is it flickering?
ArchiveNow production of LED fixtures must first go through careful computer programming, make light panels, and then enter assembly line of assembly shop. We won't go into details. Everyone has this life experience The LED bulbs I j...
2023-03-18【Archive】
View -
Basic literature on operational amplifiers
ArchiveAn op amp (abbreviated as op amp) is a very high gain circuit. In real circuits, some functional module is usually combined with a feedback circuit. This is an amplifier with a special coupling circuit and feedback. Its output can...
2023-03-18【Archive】
View -
The SD card is broken, can it be fixed this way?
ArchiveMany modern NAND flash devices now use a new architecture that integrates interface, controller, and memory chip into a common ceramic layer. We call it monolithic packaging. Until recently, all memory cards such as SD, Sony M...
2023-03-18【Archive】
View -
Do you know why k is lower case for kV voltage?
ArchiveWhy is k for kV in lower case? Units of measurement in international standards are usually written in lowercase letters. Only when referring to units named after names such as volt V, ampere A, kelvin K, watt, watts, etc. name...
2023-03-18【Archive】
View -
Common Mistakes of Electronics Engineers
ArchiveMyth 1. Cost savings Common mistake #1.What color should I choose for bar indicator? Personally, I like blue better, just choose it. A positive decision. Red, green, yellow and orange indicator lights available on market, regardl...
2023-03-18【Archive】
View -
What is difference between synchronous rectification and non-synchronous rectification?
ArchiveThe switching power supply is designed to charge inductor when power tube is turned on, and inductor accumulates energy; when power tube is turned off, inductor releases energy, thereby realizing voltage conversion. When power...
2023-03-18【Archive】
View -
Can a PCB trace angle be 90 degrees?
ArchiveNow whenever you open PCB layout manual of original SoC factory, it will mention high speed signal routing angle, and it will say that the high speed signal should not be directed at a right angle, but at a 45 degree angle a round...
2023-03-18【Archive】
View -
"Jingzhen" stroked you: "Do you know how I work?"
ArchiveCrystal oscillators can be seen all over PCB. While processor is in use, there must be a crystal oscillator. Even if there is no external crystal oscillator, there is a crystal oscillator inside chip. 1. Overview of crystal osci...
2023-03-18【Archive】
View -
Explain in detail difference and application of two-three-four-wire system.
ArchiveA 220 VAC instrument must be a four-wire system A four-wire signal device means that power circuit and signal circuit are independent, separated by an isolating circuit, and used to isolate a standard 4-20mA signal. So signal must...
2023-03-18【Archive】
View -
One Article for Understanding PFC (Power Factor Correction)
ArchiveWhat is Power Factor Correction? What is power factor correction? Power factor correction. In 1950s, improvements were made to eliminate inefficiency in powering AC devices with inductive loads due to phase mismatch between volta...
2023-03-18【Archive】
View
Hot Posts

- In PCB industry, we all need to know these 5 important common sense rules.
- 6500 words about switching power supply design, haberdashery, collect first, then study!
- Can you answer these questions about using capacitors?
- Comprehensive MLCC Failure Analysis
- Why is shielded wire so important? But remember about one-way grounding!
- With these two schematics, PCB design is easy!
- What is a magnetic sensor? The most common types of magnetic sensors and their applications
- A simple understanding of op amps...